• Removing drive belts from the base shaft
• Possibility of removing the base shaft by motorizing the various devices, including the oil pump
• By motorizing the tappers (12U*, 13Y, 13G, 13D, etc.) it is possible to eliminate the tapping/untapping cams as well as their tapping control systems. The operator then only has to adjust the spindle counting and feed cams.
• Synchronizing polygoners allows them to :
  • Different relationships in the execution of a piece
  • To use the maximum speed of the doll whatever the synchro ratio
  • Removing the mechanical stress of the polygoner on the doll.

All these motors can be installed either independently of the machine control or integrated into a Motion control controlled by the motion controller via the touch screen.

* By motorizing the 12U it becomes a tapper.